How to Remove Stickers From Inside Rear Car Window: Quick & Easy

The lovely sticker on the inside of your rear car window offers your vehicle’s interior a fresh new look. This will not last indefinitely, since you will need to remove it to add a fresh sticker or maintain the area clear.

How to remove stickers from inside rear car window?’ is the question presently. Is it possibly feasible to remove the stickers without scratching your rear window?

Here is a summary table of all five main methods to remove decals and stickers from inside car windows:

Method	Steps
Window cleaner	Spray, chip, and pull the sticker up slowly. Repeat until fully removed.
Rubbing alcohol	Apply rubbing alcohol, wait, and peel the sticker. Use a razor blade if needed.
Goo Gone	Spray Goo Gone, wait, and easily remove the sticker.
Ice	Hold the ice pack to cool the adhesive, then use a razor blade to remove the sticker.
WD-40	Remove as much of the sticker as possible, spray WD-40, let it soak, and wipe it off with a cloth.

How to Remove Stickers From Inside Rear Car Window

It’s far easier to apply rear car window stickers than it is to remove them. Because once they are on the window, they are exposed to both hot and cold temperatures, this is the case.

Window stickers adhere strongly to the window glass due to the sun heating the glue on the sticker and then contrasting with the cooler night temperature, making them incredibly difficult to remove without a battle.

Removing stickers from rear car windows can be done in a variety of ways. Here are some of them:

• Razor blade
• Adhesive remover
• Heat
• Rubbing alcohol
• Ice
• WD-40

The above methods can help you remove stickers from the inside of your rear automobile windows. However, I highly recommend using a razor blade and adhesive remover. These two approaches are suggested since they are both safe and effective. The other procedures may risk the car window and trim if not utilized properly.

These damages may be more problematic than the rear car window stickers you attempt to remove.

How to Remove Rear Car Stickers Using Razor Blades

Materials needed:

• Microfiber towel or a soft cloth
• Cleaner for windows
• Adhesives remover
• Razor blade
• Water for rinsing

Important note: The razor blade you use to remove the sticker from your car’s interior window may cause harm to the surface. What you want to do is gently scratch it.

Step-by-step instructions:

1. Clean your windows with a glass cleaner

Depending on your solution, spray or apply a glass cleaner to the location. Make sure to get an ammonia-free glass cleaner so that the rubber around your car’s back window doesn’t get damaged.

Wipe the sticker place with a microfiber towel after applying the glass cleaner. The purpose of utilizing a soft or microfiber material is to avoid scratching the interior surface of your car’s rear window.

2. Take away the Sticker

The glass cleaner has thoroughly cleaned the back of your internal window. The next step is to use a razor blade to remove the sticker. To avoid accidentally scratching the glass of your inside rear window, get a razor blade with no rust or dents.

You can get a razor blade scraper to prevent scratching the window glass as it has a grip rather than the blade itself. Make sure to scrape gently.

Now reapply the glass cleaner to create a slick surface that will allow the razor blade to glide through the sticker place on the glass.

Start removing the sticker from the glass by holding the razor blade at a 45-degree angle. If you peel the sticker while scraping, you can lessen the amount of residue it leaves behind. To avoid harming your vehicle’s interior glass, carefully scrape the sticker from your interior. Keep an eye out for your fingers, cleaning; you don’t want to get wounded.

3. Remove any remaining residue

You will be left with sticker leftovers after thoroughly removing the sticker from the inner rear automobile window. You want to get rid of the residues, so you’ll have to do some extra gentle scraping. You can use adhesive remover to wipe the leftovers without scratching them.
Use your razor to remove any remaining adhesive. Apply the same method we used to remove the sticker before.

4. Clean your windows using glass cleaner

If the adhesive remains, use glass cleaner to remove it. Rep the first procedure, this time using the cleaner and a microfiber towel to wipe it down. A razor blade is no longer required. Make sure to get rid of the glue as well.

5. Dry the area

Finally, clean water should be used to rinse the area. Make sure you don’t get water on your car’s interior seats.

Check out This Video for How to Remove a Vinyl Window Decal!

How to Remove Rear Car Window Stickers Using Adhesive Remover

Select your favorite adhesive remover and check the labels to ensure it’s safe to use on a surface like a back car window and the automobile to avoid damaging paint and window tinting.

Wipe any dirt and grime from the window with a car glass cleaner and a microfiber towel. Apply adhesive remover carefully to the sticker, or as the manufacturer directs, and let for 5-10 minutes.

Once the sticker has been loosened enough by the adhesive remover, scrape it off with a plastic scraper found in your kitchen. Use one that won’t leave a mark.

Clean the sticker with a folded paper towel if you don’t have a plastic scraper. Start scrubbing from a corner with a folded paper towel, then slowly work toward the middle.

Scrub or scrape the sticker and any leftover adhesive until it is fully gone. Then clean the area with a microfiber towel and auto glass cleaner before buffing the glass to shine.

This method isn’t the most convenient because it often results in a sticky mess when the adhesive dissolves, but it is safe and effective. You’ll need patience to utilize this procedure, as it requires a great deal of scraping and cleaning, as you can see.

Because the stickers are being removed from the inside, a surface test should be performed to ensure that the adhesive remover does not hurt surfaces such as car seats and doors.

Cover the surface with an old cloth or towel to keep the adhesive remover from contacting the car.

If you don’t have much patience and don’t want to deal with all of the stickiness, attempt the first option, which involves using razor blades.

Use Goo Gone

Goo Gone is a commercial cleaning product designed to remove sticky residues from various surfaces, such as stickers and adhesive residue. It is commonly used for cleaning purposes.

To use Goo Gone:

1. Spray Goo Gone directly onto the sticker or adhesive residue that you want to remove.
2. Allow the product to sit on the surface for a few minutes. This will give it time to penetrate and loosen the adhesive.
3. Using a cloth or paper towel, gently rub the area where the sticker or residue is located. You should start to notice that the adhesive begins to dissolve.
4. Continue to rub and wipe the surface until the sticker or residue is completely removed.
5. If necessary, repeat the process for stubborn or larger stickers.
6. Once the sticker is removed, clean the area with soap and water to remove any remaining Goo Gone residue.

Alternatives to Remove Stickers from the Inside of a Rear Car Window

As previously stated, stickers can give beauty to your automobile inside, but you must remove them once the beauty has faded. You can try some alternative options below.

1. Using heat

This method only requires a hand dryer, paper towels, and warm water.

Turn on the highest setting on the hand dryer. If you have one, you can also use a heat gun. Hold it for a minute or two over the sticker. Quickly peel the corner of the sticker away from the glass surface, then slowly remove away.

To remove the residue, use hot water and paper towels.

2.  Rubbing alcohol

Remove the sticker from the glass by cleaning it, applying rubbing alcohol, and peeling it away. Reapply to remove the glue from the glass completely, then clean it. To shine the area, use the other side of the cleaning towel to buff it.

If not properly diluted, rubbing alcohol can permanently damage automobile paint and other surfaces. Make sure you’re using the correct concentration.

3. Ice

A sticker on your rear inside the window can be removed with a pack of water. Let the ice cool on the sticker place before peeling it away without scratching it.

4. Razor and Windex

Some dealerships remove window stickers with a straight razor blade and Windex without damaging the paint. Simply squirt Windex on the sticker and scrape it off using a razor blade at an angle. If there are any residues left, use extra Windex and fine steel wool to wipe them up.

Note: Steel wool can scratch the glass, so proceed with caution.

5. WD-40

Remove as much of the sticker as you can by gently peeling it away. Wait a few minutes after spraying WD-40 on the remaining sticker bits and adhesive residue. Wipe the spray away with a moist cloth once the timer has expired. If necessary, clean the area.

Troubleshooting: Common Challenges and Solutions

When dealing with adhesive residue, you may encounter common challenges such as sticker remnants that won’t come off, damage to the rear window during removal, and stuck residue or adhesive that’s difficult to remove. Here are some solutions for these challenges:

Sticker remnants that won’t come off:

This is one of the most common issues with sticker removal. Here is how I deal with it:

1. Increase heat: Use a heat gun or hairdryer to the sticker remnants. The additional heat will soften the adhesive, making it easier to remove.
2. Soak with adhesive remover: Apply a commercial adhesive remover or a mixture of warm soapy water to the sticker remnants and let it soak for a few minutes. This will help loosen the adhesive, making it easier to scrape off.
3. Use a plastic scraper or credit card: Gently scrape the sticker remnants using a plastic scraper or credit card. Start from the edges and work your way toward the center. Be careful not to scratch or damage the window.

Damage to the rear window during removal:

This happens when one doesn’t have enough experience using razer blades. You should:

1. Be cautious with sharp tools: When using a razor blade or scraper, exercise caution to prevent any accidental damage to the rear window. Use gentle and controlled motions while removing the tint or adhesive.
2. Adjust heat levels: If you’re concerned about the window’s sensitivity, lower your heat on your heat gun or hairdryer. This can reduce the risk of damage to the rear window while providing enough heat to loosen the adhesive.
3. Seek professional help: If you’re unsure about the process or worried about potential damage, it’s advisable to seek assistance from a professional car detailer or window tinting specialist with experience handling such situations.

Stuck residue or adhesive that’s difficult to remove:

Some commercial stickers or decals are very hard to remove. With these stubborn, you should:

1. Adhesive remover: Apply a commercial adhesive remover to the residue or adhesive and let it sit for a few minutes. This will help break down the adhesive, making it easier to remove.
2. Soapy water and scraper: Add a solution of warm soapy water to the residue. Allow it to soak for a few minutes, then gently use a plastic scraper or credit card to scrape off the residue. Reapply the solution as needed.
3. Rubbing alcohol: Dampen a cloth or sponge with rubbing alcohol and gently rub the residue or adhesive. The alcohol helps dissolve the adhesive, making it easier to wipe away.
4. Heat and scrape: Apply heat to the residue or adhesive using a heat gun or hairdryer, then use a plastic scraper or credit card to scrape it off. The heat softens the adhesive, making it less sticky and easier to remove.

Remember to work slowly and patiently, using gentle techniques to avoid damaging the window or leaving behind excessive residue. If the challenges persist or you’re unsure about the process, you should seek professional assistance to ensure the safe and effective removal of tinted windows and adhesive residue.

Frequently Asked Questions

Can I use a razor blade to remove stickers from my rear car window?

Of course, you can. A razor blade is preferred when dealing with sticker removal. Ensure the razor blade is sharp and held at a shallow angle to avoid scratching the window.

How do I avoid scratching or damaging the window during sticker removal?

It’s crucial to use proper tools and techniques. Consider using a plastic scraper or credit card instead of a razor blade, as they are less likely to cause damage. Applying heat to the sticker using a heat gun or hairdryer can soften the adhesive, making it easier to remove without excessive force.

Are there any alternative methods for sticker removal?

Yes, there are many. You can try using adhesive removers, rubbing alcohol, or warm soapy water to break down the adhesive and make it easier to peel off the sticker. Also, some adhesive removal products specifically designed for automotive use are available in the market, which can be effective alternatives.

Can I use household cleaners like Windex or glass cleaners to remove stickers?

Using household cleaners like Windex or glass cleaners to remove stickers from car windows is generally not recommended. While they might help clean residue after removing the sticker, they may not effectively dissolve the adhesive. It’s better to use adhesive removers, rubbing alcohol, or warm soapy water specifically designed for a sticker or adhesive removal.

How do I remove stickers from rear windows with defrosters?

When removing stickers with defrosters, it’s important to be cautious and avoid damaging the defroster lines. Use a heat gun or hairdryer to warm the sticker and adhesive, making it easier to peel off without putting excessive pressure on the defroster lines. If using a scraper, be gentle and avoid scraping directly over the lines to prevent damage.

Check out This Video for How to Easily Remove Stickers Decals Off Glass Windows

How do I remove decals from car windows?

To remove decals from car windows, you can use the following steps:

1. Heat the decal: Use a heat gun or hairdryer to warm the decal, softening the adhesive.
2. Peel off the decal: Once heated, start peeling off the decal from one corner using your fingers or a plastic scraper.
3. Remove residue: If adhesive residue is left behind, use an adhesive remover, rubbing alcohol, or warm soapy water to dissolve it. Gently scrape off the residue with a plastic scraper or cloth.
4. Clean the window: Wipe the window clean with a microfiber cloth to remove any remaining residue or cleaning solution.

Remember to work slowly and cautiously to avoid damaging the window or leaving adhesive residue.

Conclusion

Stickers will always find their way inside your rear car window; therefore, it is essential to know how to remove stickers from the inside of a rear car window.

The majority of the approaches covered in this article are safe and effective and simple to implement. Some of them should be taken with caution since if they are overused. They might cause irreversible damage.