How to Get Air Out of Brake Lines Without Bleeding Them in 3 Easy Steps

This article may contain affiliate links. For details, visit our Affiliate Disclosure page.

How to Get Air Out of Brake Lines Without Bleeding Them

Do you wonder how to get air out of brake lines without bleeding them? In previous articles, I wrote about some simple steps you can take to remove “powerful” air from your brakes. In this article let’s study how to get the air out of the brake lines without bleeding them!

How to Get Air Out of Brake Lines Without Bleeding Them

How to Get Air Out of Brake Pads

Step 1: Disconnect the Negative Cable From Its Nut

The first thing you will want to do is disconnect the negative cable from its nut. This is located under your car and is marked by a red arrow. Once the cable is disconnected, it should be sitting sideways with the “lever” facing down.

Step 2: Check Out Some Damage to Your Brakes

There could be some damage to your brakes that you cannot see. If your brakes have even the tiniest amount of wear, you need to bleed them before you replace them. You can use an air compressor or shop vac to remove the excess pressure. You must be very careful when doing this. You don’t want to cause further damage to the brakes.

Step 3: Check Out Your Calipers

Next, you should get the hood up to take a look at your calipers. They should be completely clean with no dirt, oil or other debris on them. If they are dirty, you should clean them before you put them back in. If there is excessive build-up, you should take them out immediately and follow the steps I just wrote about. If you see any leaks, you need to get them sealed. You will be able to tell which ones need cleaning and which ones don’t.

How to Get Air Out of Brake Lines Without Bleeding Them

If you are wondering how to get air out of brake lines without bleeding them, you should do it before you apply any force to them. Apply pressure to the brake pedal slowly and firmly. Make sure you don’t apply too much pressure because you could cause damage to the rubber on the master cylinder. It will save you money in the long run.

How to Get Air Out of Brakes That Are Clogged

Now that you know how to get air out of brake pads, let’s talk about how to get air out of brakes that are clogged. This is usually a problem that only affects older cars. The reason is that buildup can occur under the cap that seals the brake discs.

How to Get Air Out of Brake Calipers

To get air out of brake calipers, you need to use a wire brush or a sponge. Use something smooth and not rough. You don’t want to scrape the brake caliper. Also, make sure you are not applying too much pressure when cleaning them. Any time you spread paint or solvent on your brakes, it will spread into the caliper as well.

You need to use a really steady hand when doing this job. A wobbly brush could cause serious damage to your discs. You don’t want to get air out of brake lines either. If you get air out of brake hose hoses, you could ruin your rotors or master cylinder. It’s not something I would want to attempt to do myself.

How to get air out of brake calipers is also pretty simple once you get the hang of it. You just use a shop brush that is specifically designed to work on caliper wheels. You’ll find that this can often get very dirty as the wheel has been in use so many times. Once you’ve cleaned it, spray the area again with an anti-static agent.

Now you know how to get air out of brake pads, you need to take care of the calipers. Clean them properly with brake cleaner and a good quality detergent. Rinse thoroughly after cleaning. Follow this up by wiping them down with a clean rag. Proper maintenance of your brakes will keep them working properly for a longer amount of time.

How to Get Air Into Your Car

The last step is to get air into your car. You should have a shop vac, or canister, available at your local gas station. Spray the wheel areas with the anti-static agent. Leave the device on the device for a good 20 minutes. This will effectively pull the accumulated gunk out of the pipes. Once the anti-static agent has died down, you can vacuum away the gunk.


If you use your car regularly, chances are you have encountered some problems with your brakes. Check the brakes regularly to ensure the safety of your every ride.


Rate this post